Overview - Camshaft Timing Chain
WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Tightening specification: 9 Nm
- Jump Protector
- Crankshaft
- With chain sprocket for the camshaft timing chain
- Guide Rail
- Pay attention to the installed position.
- Bolt
- Tightening specification: 23 Nm
- Guide pins
- 5 Nm + an additional 90° turn
- Replace
- For guide rail
- Guide Rail
- Pay attention to the installed position.
- Bolt
- Tightening specification: 23 Nm
- Camshaft Chain Sprocket
- For the intake camshaft
- Installation position: labeled side is legible from behind
- Guide Pins
- 5 Nm + an additional 90° turn
- Replace
- For guide rail
- Chain Sprocket
- For the balance shaft
- Guide Rail
- Pay attention to the installed position.
- Guide Pins
- Tightening specification: 23 Nm
- For guide rail
- Camshaft Chain Sprocket
- For the intake camshaft
- Installation position: labeled side is legible from behind
- Bolt
- Tightening specification: 23 Nm
- Guide pins
- Tightening specification: 5 Nm + an additional 90° turn
- Replace
- For guide rail
- Guide Pins
- For tensioning track
- Tightening specification: 23 Nm
- Tensioning Rail
- Chain Tensioner
- For the camshaft timing chain
- Bolt
- 5 Nm + an additional 90° turn
- Replace
- Camshaft Timing Chain
- Remove from the camshafts, refer to CAMSHAFT TIMING CHAIN, REMOVING FROM CAMSHAFTS .
- Before removing, mark the direction of rotation with paint
- Removing and installing, refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .