Flange/Driveshaft And Seal With Rear Final Drive Removed

Special tools and workshop equipment required 

• Puller VW 391
• Slide Hammer - Complete Set VW 771
• Pulling hook VW 771/37
• Thrust Piece T40112
• Retainer 3028
• Seal Driver-Frt Wheel Bearing 3143
• Adapter T10235
• Friction Meter VAS 6222
• Inductive Heat Unit VAS 6414
• Sealing Grease G 052 128 A1
• Locking Fluid AMV 185 101 A1
• Three M8 x 25 bolts
• 2 bolts M10 x 40

-- Follow the General Repair Instructions. Refer to COMPONENT DESCRIPTION .

-- Remove rear final drive. Refer to REAR FINAL DRIVE .

-- Attach the rear final drive to the holding fixture VW 540 using M10 x 40 bolts -arrows-.

Fig 1: Attaching Rear Final Drive To Holding Fixture

Courtesy of AUDI OF AMERICA, LLC

-- Measure the friction torque before loosening the pinion nuts.

Fig 2: Identifying Special Tool

Courtesy of AUDI OF AMERICA, LLC

-- Write down this value.

-- Attach the 3028 to the flange/driveshaft with the bolts -A-.

Fig 3: Attaching 3028 To Flange/Driveshaft With Bolts -A-

Courtesy of AUDI OF AMERICA, LLC

-- Attach the T10235 in the threaded hole under the flange/driveshaft.

-- Loosen the pinion nut. The 3028 will be supported by the T10235 -arrow-.

-A- three M8 x 25 bolts

-B- 32 mm socket

-C- bar

-- Install the VW 391 with two M8 x 25 bolts -arrows-.

Fig 4: Pulling Off Drive Shaft Flange Using Puller VW 391

Courtesy of AUDI OF AMERICA, LLC

-- Remove the flange/driveshaft.

-- Remove the shaft seal.

Fig 5: Removing Shaft Seal

Courtesy of AUDI OF AMERICA, LLC

-- Clean the thread on the pinion.

-- Coat the outer circumference of the shaft seal with gear oil.

Fig 6: Installing New Shaft Seal All Way Without Tilting It

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing and dust lips halfway with sealing grease G 052 128 A1.

-- Install the new shaft seal all the way without tilting it.

-- Warm the flange/driveshaft to approximately 80 °C (176 °F) with an VAS 6414.

Fig 7: Driving On Flange/Driveshaft Far Enough Until Circlip Can Be Installed

Courtesy of AUDI OF AMERICA, LLC

-- Install the new flange/driveshaft.

-- Coat the thread on the new nut with locking fluid AMV 185 101 A1.

-- Attach the 3028 to the flange/driveshaft with the bolts -A-.

Fig 8: Attaching 3028 To Flange/Driveshaft With Bolts -A-

Courtesy of AUDI OF AMERICA, LLC

-- The 3028 must be supported by the housing brace -arrow- when tightening the pinion nut.

-A- three M8 x 25 bolts

-B- 32 mm socket

-C- bar

-- Tighten the new pinion nut just far enough until the friction torque, measured prior to removal, is reached.

Fig 9: Identifying Special Tool

Courtesy of AUDI OF AMERICA, LLC

-- Install rear final drive. Refer to REAR FINAL DRIVE .

-- Check the gear oil in the rear final drive. Refer to REAR FINAL DRIVE GEAR OIL, CHECKING .