Wheel Bearing Housing Bonded Rubber Bushing, Removing And Installing, Fwd Vehicles: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Rubber Bonded Bushing

Courtesy of AUDI OF AMERICA, LLC

-- Place the front bonded rubber bushing in the Bearing Installer - Wheel Bearing Bushing - Sleeve T40184/3. The "thin" collar -arrow- must face upward.

In order to install the front rubber bonded bushing, the Bearing Installer - Wheel Bearing Bushing - Pressure Plate T40184/2 -3- must be mounted on the front rubber bonded bushing in such a way so that the lugs -2- fit into the grooves -4-.

-- Press the front rubber bonded bushing all the way onto the thrust plates -1- and -6-.

Fig 2: Pressing Front Rubber Bonded Bushing All Way Onto Thrust Plates

Courtesy of AUDI OF AMERICA, LLC

Press Plate VW401 Order as illustrated.
Sleeve T40184/3
Front bonded rubber bushing
Press Piece - Rod VW408A
Bearing Installer - Wheel Bearing Bushing - Pressure Plate T40184/2
Press Plate VW402 Order as illustrated.

-- Then slightly pull apart the thrust plates -1- and -6-.

-- Press the front rubber bonded bushing approximately 2 mm out of the Sleeve T40184/3.

Fig 3: Pressing Front Rubber Bonded Bushing Approximately 2 Mm Out Of T40184/3

Courtesy of AUDI OF AMERICA, LLC

a = 2 mm

-- Remove the Press Piece - Rod VW408A and insert the Press Piece - Rod VW411.

-- Position the wheel bearing housing on the Shop Press VAG1290A.

-- Mount the front rubber bonded bushing (not shown in the illustration), the pressure plate -3- and the sleeve -1- on the wheel housing bearing.

Fig 4: Mount Front Rubber Bonded Bushing

Courtesy of AUDI OF AMERICA, LLC

Sleeve T40184/3
Press Piece - Rod VW411
Bearing Installer - Wheel Bearing Bushing - Pressure Plate T40184/2 Pay attention to the installation position of the front rubber bonded bushing.

-- Place the tools on the front bonded rubber bushing and the wheel bearing housing -3- as illustrated.

Fig 5: Pressing In Front Bonded Rubber Bushing

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When mounting the wheel bearing housing onto the Sleeve T40184/1 be careful not to damage or push the rubber grommet on the rear rubber bonded bushing.

-- Slowly press the front rubber bonded bushing in (not shown in the illustration) until the sleeve -2- can be pulled out at the top.

Press Piece - Rod VW411
Sleeve T40184/3
Wheel Bearing Housing
Bearing Installer - Wheel Bearing Bushing - Sleeve T40184/1. The side with the groove must face the wheel bearing housing. On a bonded rubber bushing with a "positioning tab", this is in the groove on the Bearing Installer - Wheel Bearing Bushing - Sleeve T40184/1.
Press Plate VW402

-- Slowly press the front rubber bonded bushing -2- so that it is even with the edge -arrow- of the wheel bearing housing.

Fig 6: Pressing Front Rubber Bonded Bushing Into Wheel Bearing Housing

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -item 3-.

-- Install the wheel bearing housing, refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING, FWD VEHICLES .