Bonded rubber bushing, Removing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove wheel bearing housing, refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING .
In order to remove the bonded rubber bushing, the Bearing Installer - Wheel Bearing Bushing - Pressure Plate T40184/2 -3- must be mounted on the bonded rubber bushing so that the knobs -2- fit into the grooves -4-.
-- Place the tools on the bonded rubber bushing and the wheel bearing housing as illustrated.
- Press Piece - Rod VW411
- Bearing Installer - Wheel Bearing Bushing - Pressure Plate T40184/2
- Wheel Bearing Housing
- Bearing Installer - Wheel Bearing Bushing - Sleeve T40184/1. The side with the groove must face the wheel bearing housing. On a bonded rubber bushing with a "positioning tab", this is in the groove on the Bearing Installer - Wheel Bearing Bushing - Sleeve T40184/1.
-- Press out the bonded rubber bushing.