After-Run Coolant Pump -V51-, REMOVING AND INSTALLING, NON-HYBRID VEHICLES WITH ALL ENGINE CODES EXCEPT CDZA: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Air Intake Hose Components

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -arrows- and remove the air guide hose.

NOTE:

Ignore item -1-.

NOTE:

Lay a cloth below the coolant pipe to catch escaping coolant.

-- Clamp off and remove the coolant hoses -arrows- with Hose Clamps - Up To 25mm 3094.

Fig 2: Identifying After-Run Coolant Pump Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

-- Remove the bolt -1- and the After-Run Coolant Pump -V51-.