Driveshaft To Rear Final Drive 0BE And 0BF - Tightening Specification And Sequence

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2015 Audi RS 5, and 2014 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Always replace the driveshaft bolts -1-.

Fig 1: Counterholding Using Counterhold Tool Touareg V10 T10172 And Adapters T10172/5
Courtesy of AUDI OF AMERICA, LLC
Counter hold using the counterhold Tool Touareg V10T10172 and adapters T10172/5 (M8 bolts) or T10172/6 (M10 bolts).

-- Tighten the bolts -1- in 3 steps as follows:

Step	M8 and M10 Bolts	Tightening Specification/Additional Turn
1.	-1-	Next to the color dots 30 Nm ¹⁾
2.	-1-	The remaining all around 30 Nm
3.	-1-	90° additional turn all around
¹⁾ The CV joint will be pushed toward the opposite side reducing the imbalance.