Flange/Driveshaft Seal, Rear Final Drive 0BE: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2015 Audi RS 5, and 2014 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exhaust System Clamping Sleeves

Courtesy of AUDI OF AMERICA, LLC

The rear final drive is installed

-- Separate the exhaust system at the clamping sleeves -1 and 2-.

-- Remove rear portion of exhaust system. Refer to the appropriate service information .

NOTE:

A second technician will be needed to help remove the rear section of the exhaust system.

-- Open the gear oil drain plug -arrow- and let approximately 300 ml gear oil drain out.

Fig 2: Gear Oil Drain Plug

Courtesy of AUDI OF AMERICA, LLC

-- Install and tighten the new drain plug -arrow-. Tightening specification, refer to item 16

-- Remove the driveshaft from the rear final drive. Refer to DRIVESHAFT, REMOVING FROM REAR FINAL DRIVE AND INSTALLING .

Fig 3: Identifying Mark Position Of Driveshaft Flange To Rear Final Drive

Courtesy of AUDI OF AMERICA, LLC

-- Guide the driveshaft between the fuel tank and the rear subframe downward and tie it to the side.

-- Remove any high temperature grease inside the flange/driveshaft.

Fig 4: Identifying Circlip, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the locking ring -arrow-.

-- Mark the position of the flange/driveshaft -B- to the pinion -A- -arrow-.

Fig 5: Locating Mark Position Of Flange/Driveshaft To Pinion

Courtesy of AUDI OF AMERICA, LLC

NOTE:

This mark -arrow- is needed so that the color dot -C- on the outside of the flange remains in its earlier position.
Only by doing this can the smallest imbalance possible inside the rear final drive be guaranteed.

-- Remove the flange/driveshaft.

Fig 6: Two-Arm Puller Kukko 20-10