Clutch Valve Or Clutch Valve 2: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2015 Audi RS 5, and 2014 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

The ball -5-, the guide -4- (the smaller diameter faces the spring) and the spring -3- must be installed in the opening inside the housing -6- for the clutch valve -- -2-.

Fig 1: Identifying Clutch Valves
Courtesy of AUDI OF AMERICA, LLC

-- Coat the new O-rings -arrows- with ATF and install the clutch valve --.

-- Pre-tighten the bolts -1- evenly hand-tight. Then tighten them to the tightening specification, refer to item 13.

Further installation is in the reverse sequence to removal. Note the following when doing this:

NOTE:

Connector allocation for the oil pressure/temperature sensor -- and the clutch valves -- :

Fig 2: Oil Pressure/Temperature Sensor Connector

Courtesy of AUDI OF AMERICA, LLC

-1- = oil pressure/temperature sensor 2 -G640- connector

-2- = oil pressure/temperature sensor -G437- connector

-3- = AWD clutch valve 2 -N446- connector

-4- = AWD clutch valve -N445- connector

-- Attach the wiring harness bracket to the rear final drive. See Figure.

-- Fill the ATF in the rear final drive. Refer to ATF IN REAR FINAL DRIVE 0BF AND 0BE, FILLING .

-- Install the rear section of the exhaust system free of tension. Refer to the appropriate service information .