Overview - Balance Shaft
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Replacing
- Balance Shaft
- Intake side
- Must be replaced after removing
- Lubricate the bearing with engine oil
- Replacing, refer to BALANCE SHAFT, REMOVING AND INSTALLING, INTAKE SIDE .
- Balance Shaft
- Exhaust side
- Must be replaced after removing
- Lubricate the bearing with engine oil
- Replacing, refer to BALANCE SHAFT, REMOVING AND INSTALLING, EXHAUST SIDE .
- Bolt
- 9 Nm
- Replacing
- Pipe for the Balance Shaft
- Installed position, refer to Fig 2
- Balance Shaft Seal, Exhaust Side,
- Replacing, refer to BALANCE SHAFT SEALING RING, REPLACING, INTAKE SIDE .
- The pin from the balance shaft pipe must fit into the groove -arrow-