Servotronic Solenoid Valve -N119-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Replacement is only possible when the steering gear is removed.

-- Remove the steering gear, refer to HYDRAULIC POWER STEERING GEAR, REMOVING AND INSTALLING .

-- Always the clean steering gear -6- in the Servotronic Solenoid Valve -N119- -3- area.

Fig 1: Identifying Servotronic Solenoid Valve Remove/Install Components

Courtesy of AUDI OF AMERICA, LLC

-- Make sure dirt cannot get into the steering gear -6-.

-- Disconnect the connector -8-.

-- Make sure dirt cannot get into the connector -8-.

-- Remove the bolts -1- and -2-.

-- Remove the Servotronic Solenoid Valve -N119- -3- from the steering gear -6-.

-- Remove the screen -7- from the steering gear -6- and clean steering gear, if necessary.