Crankshaft Seal, Replacing, Transmission Side

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Seal Installer - Crankshaft T10122A
Puller - Crankshaft/Power Steering Seal T20143/2

Procedure

Fig 1: Prying Out Sealing Ring Using Extractor Lever T20143/2

GWWA13-0624

Courtesy of AUDI OF AMERICA, LLC

The transmission is removed, refer to TRANSMISSION, REMOVING AND INSTALLING . .

-- Remove the drive plate, refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Pry out the shaft seal using Puller - Crankshaft/Power Steering Seal T20143/2.

-- Clean the running and sealing surface.

-- Place the Assembly Device T10122/1 on the Pull Sleeve T10122/2 and slide the shaft seal -A- onto the pull sleeve.

Fig 2: Identifying Seal, Sleeve T10122/1 And Assembly Tool T10122/2

GWWN13-0782

Courtesy of AUDI OF AMERICA, LLC

-- Remove the assembly aid.

-- Position the Pull Sleeve T10122/2 with shaft seal -1- on the crankshaft.

Fig 3: Positioning Shaft Seal Onto Crankshaft

GWWA13-0625

Courtesy of AUDI OF AMERICA, LLC

-- Press shaft seal in evenly all around with Thrust Piece T10122/3 until flush.

Fig 4: Pressing Shaft Seal Onto Crankshaft

GWWA13-0626

Courtesy of AUDI OF AMERICA, LLC

-- Install the drive plate, refer to DRIVE PLATE, REMOVING AND INSTALLING .