Crankshaft, Measuring Radial Clearance
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Plastigage®
Procedure
-- Remove the guide frame and clean the bearing journals.
-- Place the Plastigage® over the entire width of the bearing journal or into the bearing shells.
- Plastigage® must rest in center of bearing shell.
-- Position the guide frame and tighten the old bolts to the final tightening specification. Refer to -item 7- Bolt (See Figure). Do not turn the crankshaft when doing this.
-- Install the guide frame.
-- Compare width of Plastigage® with calibrated scale.
Radial clearance:
- New: 0.015 to 0.055 mm.
- Wear limit: 0.080 mm.
-- Replace the new bolts for the final assembly.