LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (3.0L - Cylinder Head & VALVETRAIN - Engine Code(S): CTUC & CTUD) >> 15 Cylinder Head, VALVETRAIN >> VALVETRAIN >> Overview - VALVETRAIN >> Camshaft Guide Frame, Tightening Sequence

Camshaft Guide Frame, Tightening Sequence

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Camshaft Guide Frame Bolts Tightening Sequence (Reverse For Loosening)
GWWA15-10312Courtesy of AUDI OF AMERICA, LLC
NOTE:

The guide frame for the left cylinder head camshaft is shown in the illustration. The right cylinder head is identical.

Replace the bolts that were tightened with an additional turn.

-- Tighten the bolts in three steps and in the sequence shown:

Step Bolts Tightening Specification/Additional Turn
1. -1 to 21- Install the bolts all the way in by hand
  • The guide frame must touch the entire contact surface on the cylinder head.
2. -1 to 21- 8 Nm
3. -1 to 21- Tighten an additional 90°
scientia non olet · About LEMON Manuals