LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (3.0L - Cylinder Head & VALVETRAIN - Engine Code(S): CTUC & CTUD) >> 15 Cylinder Head, VALVETRAIN >> Cylinder Head >> Cylinder Head Cover, Removing And Installing >> Left Cylinder Head Cover, Removing And Installing >> Installing

Left Cylinder Head Cover, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the cylinder head seal if it is damaged.

Replace the cylinder head cover bolts when replacing the damaged seal.

Replace the O-ring.

-- Clean any oil or grease off the sealing surfaces.

-- Tighten the left cylinder head cover bolts, refer to Figure.

-- Install the ignition coils, refer to IGNITION COILS, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals