Overview - Timing Mechanism Drive Chain
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Guide Rail
- Bolt
- 10 Nm +90°
- Replace
- Bolts
- 5 Nm +60°
- Replace
- Mounting Pin
- For the drive chain sprocket
- Drive Chain Sprocket
- For left timing chain
- Bolt
- 10 Nm +90°
- Replace
- Drive Chain
- For timing mechanism
- Mark the running direction with paint for reinstallation
- Removing and installing, refer to TIMING MECHANISM DRIVE CHAIN, REMOVING AND INSTALLING .
- Bolt
- 10 Nm +90°
- Replace
- Guide Rail
- Bolt
- 8 Nm +45°
- Replace
- Bearing Plate
- For the right camshaft timing chain drive sprocket
- Asymmetrical version
- Drive Chain Sprocket
- For right timing chain
- Installed position, refer to Fig 2
- Thrust Washer
- Asymmetrical version
- Installed position, refer to Fig 2
- Mounting Pin
- For the drive chain sprocket
- Asymmetrical version
- Installed position, refer to Fig 2
- Bolt
- 30 Nm +90°
- Replace
- Seal
- Replace
- Chain Tensioner
- Removing and installing, refer to TIMING MECHANISM DRIVE CHAIN, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Crankshaft
- Bolt
- 10 Nm +90°
- Replace
- The alignment bushings in the right camshaft timing chain drive sprocket mounting pins -3- must engage in the holes in the thrust washer -1- and cylinder block.
2 -
Right Camshaft Timing Chain Drive Sprocket
4 -
Bolt