Front Noise Insulation
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Noise Insulation
- Removing:
- The front wheel spoiler is removed. Refer to OVERVIEW - FRONT WHEEL SPOILER .
-- Remove the bolts -1- and -2- as well as the bolts at the bottom of the wheel housing liner (3 bolts on each side) and then pull the noise insulation toward the rear under the bumper.
- When installing, slide the front noise insulation in under the bumper.
- Bumper Cover
- Spring Nut
- Install on the bumper cover.
- Bolt
- 2.5 Nm
- Rear Noise Insulation
- Quick Release
- Rotate 180° to the left to remove.
- When installing, the connection must engage when rotating.
- Bolt
- 2.5 Nm
- Spoiler
Vehicles with Parking Heater
-- In vehicles with a parking heater, make sure the exhaust pipe is installed correctly in the noise insulation. .