Seat Belt Height Adjuster, Removing And Installing: Installing
Install in reverse order of removal. Note The Following:
-- If parts of the seat belt system are removed due to an accident, replace the belt system mounting bolts.
A replacement seat belt height adjuster is delivered with the slide in the lowest position (installation position).
If removed seat belt height adjusters are reinstalled, these should be placed in the bottom-most position (assembly position).
-- Engage seat belt height adjuster -4- in the B-pillar.
-- Tighten the bolt -5-.
-- Install the belt relay -2- and tighten the bolt -3-.
The belt height adjuster button must not be pressed when installing the upper B-pillar trim with slide.
Ensure that the seat belt height adjuster is in the bottom-most position.
-- Make sure the mount -3- for the sliding piece for the upper B-pillar trim -1- is securely latched into the retaining pins -4- on the seat belt height adjuster.
-- Install the upper B-pillar trim -1-, refer to B-PILLAR TRIM PANEL, REMOVING AND INSTALLING, UPPER B-PILLAR TRIM PANEL , noting belt webbing -2-.
Seat belt height adjuster replacement part:
-- After installing the upper B-pillar trim, push the slide all the way up.
- This unlocks the seat belt height adjuster assembly anchorage.
Procedure for all seat belt height adjusters:
-- Check function.
When checking function, following conditions must be fulfilled:
- The seat belt height adjuster must audibly engage all 5 possible positions (and in the top-most position too).
- Belt height adjuster button must return to upper position by itself after being pressed.
- Belt relay must swing into vertical position or carrier direction by itself after tightening screw.
If any functions did not work, the seat belt height adjuster assembly must be checked; the height adjuster may need to be replaced.