LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 555 (Heating, Ventilation & Air Conditioning (1 Of 2) (As Of 06.2014)) >> 87 Air Conditioning >> Actuators >> Left Center Vent Motor -V110-, REMOVING AND INSTALLING >> Removing

Left Center Vent Motor -V110-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the driver seat as far back as possible.

-- Turn off the ignition.

-- Remove the storage compartment under the instrument panel on the driver side. Refer to Storage Compartments and Covers .

-- Remove the left footwell vent (driver side). Refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .

-- Remove the accelerator pedal module. Refer to OVERVIEW - ACCELERATOR PEDAL MECHANISM for CTUC, CAEB, CPMB, CPMA and CTUD, or ACCELERATOR PEDAL MECHANISM for CPNB .

NOTE:

The following illustrations show the arrangement of the actuators and their retaining plates on the left side of the A/C unit with the air channel leading to the left instrument panel vent -A- removed for clarity.

Fig 1: Air Guide Channel Leading Left Instrument Panel Vent Is Secured By An Expanding Clip Or A Screw
GWWA87-10514Courtesy of AUDI OF AMERICA, LLC

The air guide channel leading the left instrument panel vent -A- is secured by an expanding clip or a screw -B- onto the instrument panel crossmember -C- ; the expanding clip or the screw can only be removed when the outer instrument panel shell is removed.

-- Carefully loosen the air guide channel leading to the left instrument panel vent -A- from the A/C unit vent.

-- Mark the connector -D- if necessary (to rule out an interchange in the event several connectors are disconnected at the same time).

Fig 2: Check Lever Pin And Connector Rod Pin For Correct Fit
GWWA87-10495Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -D-.

-- Remove the bolts -C-.

NOTE:

To remove the bolt -C-, the Wrench - Special Ratchet T40083 may also be used.

-- Press the curved washer -E- toward the A/C unit and remove the shaft -A- (of the actuator -B-) from the curved washer -E-.

NOTE:

The Left Center Vent Motor -V110- operates the connector rod -F- via the curved washer -E- (and with it the door for the left indirect ventilation) and the door for the left center instrument panel vent via the lever -G-. If the lever pin -G- becomes loosened out of the curved washer guiding groove -E- when removing the actuator, the door for the left center instrument panel vent will not actuate.

Fig 3: Press Cam Plate Toward A/C And Remove Shaft From Cam Plate
GWWA87-10574Courtesy of AUDI OF AMERICA, LLC

In MY 2008, revised toothed gears -A- and a new bracket were installed as a running change (a revised collar on the toothed gear and a revised hole). Ensure the correct allocation of the toothed gear to the bracket (these parts are supplied together as a replacement part). .

The connector rod -F- actuates the door in the left center vent.

scientia non olet · About LEMON Manuals