LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 555 (Heating, Ventilation & Air Conditioning (1 Of 2) (As Of 06.2014)) >> 87 Air Conditioning >> A/C Compressor >> Belt Pulley, Removing And Installing >> BELT PULLEY, REMOVING AND INSTALLING, A/C COMPRESSOR WITH A/C Clutch -N25- >> Clutch Plate, Removing and Installing

Clutch Plate, Removing and Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition.

-- Perform the preliminary work as for replacing the belt pulley. Refer to PRELIMINARY WORK FOR REPLACING BELT PULLEY .

-- Remove the cap -A-.

Fig 1: Identifying A/C Compressor Input Shaft Components
GWWA87-11102Courtesy of AUDI OF AMERICA, LLC

-- Hold the A/C compressor input shaft -B- secure with a commercially available socket (7 mm) and turn the clutch plate -C- in direction of -arrow-.

NOTE:

The torque to drive the A/C compressor is transferred to the clutch plate -C- via the threaded connection. If, while the A/C compressor is working, the clutch plate -C- was attached to the A/C compressor shaft so tight, that it cannot be loosened (the 7 mm Allen wrench -B- cannot transmit the necessary torque) then the A/C compressor must be replaced.

scientia non olet · About LEMON Manuals