BELT PULLEY, REMOVING AND INSTALLING, "Denso" A/C COMPRESSOR, VERSION "1": Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the cap -A-.

Fig 1: Removing/Installing Belt Pulley, "Denso" A/C Compressor - Version 1

Courtesy of AUDI OF AMERICA, LLC

-- Hold the A/C compressor input shaft -B- with a 7 mm wrench and turn the drive plate -C- together with the pulley -E- in the direction of the -arrow-.

NOTE:

The torque to drive the A/C compressor is transferred to the drive plate -C- via the threaded connection. If, while the A/C compressor is working, the drive plate -C- was attached to the A/C compressor shaft so tight, that it cannot be loosened (the 7 mm Allen wrench -B- cannot transmit the necessary torque) then the A/C compressor must be replaced.

-- Remove the drive plate -C-.

-- Remove the circlip -A-.

Fig 2: Identifying Drive Plate Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the pulley -B-.