Fresh Air Blower -V2-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the passenger seats as far back as possible.

-- Turn off the ignition.

-- Remove the screw clips -A- and remove the insulation mat -B-.

Fig 1: Identifying Insulation Mat Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- Disconnect the connector -B- from the Fresh Air Blower Control Module -J126-.

Fig 2: Disconnecting Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Fresh Air Blower Control Module -J126- (version -A-). Refer to Fresh Air Blower Control Module -J126-, REMOVING AND INSTALLING .

Fig 3: Identifying Fresh Air Blower Control Module

Courtesy of AUDI OF AMERICA, LLC

NOTE:

A revised Fresh Air Blower Control Module -J126- -B- and Fresh Air Blower -V2- are being installed as a running change (depending on the vehicle version) from MY 2012. It is not always necessary to remove the Fresh Air Blower Control Module -J126- in order to remove the Fresh Air Blower -V2- on the revised version -B-.

-- Loosen the locking mechanism -A- and turn the Fresh Air Blower -V2- -B- housing in the direction of the -arrow-.

Fig 4: Locating Locking Mechanism And Turn Fresh Air Blower Housing In Direction Of Arrow

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Do not grasp fan wheel of Fresh Air Blower -V2-, force against the fan wheel or shifting the balancing weights fastened to fan wheel may cause imbalance and then problems during operation.