LEFT RETAINING PLATE WITH Footwell Door Motor -V261-, DISASSEMBLING AND ASSEMBLING
-- Remove the left retaining plate with the Footwell Door Motor -V261-. Refer to LEFT RETAINING PLATE WITH Footwell Door Motor -V261-, REMOVING AND INSTALLING .
The retaining plate with the Footwell Door Motor -V261- is only installed on vehicles equipped with the "Basis" A/C system.
Currently in this vehicle, all actuators are identical in construction. During the basic setting, the actuators are assigned and adapted corresponding to the switching sequence of the wiring. If this sequence does not conform the specification, the adjustment motors will adapt incorrectly and the door control will be wrong. Refer to MAIN WIRING DIAGRAM FOR A/C SYSTEM ACTUATORS (A/C system actuators block diagram).
The actuator shaft does not have a stop; therefore the shaft of these actuators can be inserted into the curved washer in any position.
Depending on the production date, there are different versions of the levers and connecting elements on the A/C unit. At the start of production, the levers -A- were installed with a closed pin and the connecting rod -B-. In MY 2008, the levers -C- have a slotted pin and connecting rod -D-. When replacing, be sure to use the correct version. .
- Bolt
- Footwell Door Motor -V261-
- Retaining plate
- Connecting rod
- To the doors for the left and right instrument panel vents
- Actuating lever
- Curved washer
- On the Footwell Door Motor -V261-
- Actuating lever
- Connecting rod
- to the flaps for the rear footwell vents
- Connecting rod
- To the doors for the front footwell vents
- Curved washer stop