Turbocharger, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal while noting the following:

NOTE:

Replace the seals, O-rings and the self-locking nuts.

Fill the turbocharger with engine oil at the oil supply line connection.

Hose connections and charge air system hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Install the catalytic converter. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the exhaust system free of tension. Refer to EXHAUST SYSTEM, INSTALLING FREE OF TENSION, VEHICLES WITH A REAR MUFFLER .

NOTE:

Do not reuse used coolant.

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING => Filling .

-- Check oil level.

NOTE:

After installing turbocharger, let engine idle for approximately 1 minute without increasing engine speed. This ensures adequate oil supply to the turbocharger.