Overview - Balance Shaft Drive Chain
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2015 Audi A4, and 2014 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Guide Pin
- 20 Nm
- Guide Rail
- For the timing chain
- Balance Shaft Drive Chain
- Removing and installing. Refer to Balance Shaft Drive Chain, Removing and Installing
- Guide Pin
- 20 Nm
- Tensioning Rail
- For the drive chain for the balance shafts
- Balance Shaft
- Must be replaced after removing
- Exhaust side
- Lubricate the bearing with engine oil
- Replacing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING, EXHAUST SIDE .
- Guide Pin
- 20 Nm
- Guide Rail
- For the timing chain
- Chain Tensioner
- 85 Nm
- Coat the seal with sealant
- Three Stage Chain Sprocket
- Installation position. Refer to Three Stage Chain Sprocket - Installed Position .
- O-ring
- Lubricate with engine oil
- Mounting Pin
- Lubricate with engine oil
- Installation position. Refer to Mounting Pins - Installation Position .
- Intermediate Sprocket
- The intermediate sprocket must be replaced if the bolt -item 15- is loosened.
- Washer
- Bolt
- Tightening sequence. Refer to Intermediate Sprocket Tightening Sequence .
- Always replace after removing
- The intermediate sprocket -item 13- must be replaced if the bolt is loosened.