Pressure Stand T40099, ADAPTING TO MULTITRONIC 0AW FRONT WHEEL DRIVE (FWD)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi A4, 2015 Audi A4, 2014 Audi A4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

Fig 1: Marking Locations Where Alignment Pins Are On Upper Ring

Courtesy of AUDI OF AMERICA, LLC

Input shaft removed, refer to INPUT SHAFT, REMOVING AND INSTALLING .

-- Place the input shaft centered exactly on the Pressure Stand T40099.

-- Mark the locations -arrow- where the alignment pins -1- are on the upper ring on the Pressure Stand T40099 with color.

The marked location should be somewhat in the center between the connection -2- on the Pressure Stand T40099.

-- Make a punch mark inside the marked field -a- = 6 mm from the inner edge and then make a 11 mm hole.

Fig 2: Making A Punch Mark Inside Marked Field From Inner Edge

Courtesy of AUDI OF AMERICA, LLC

-- Make two cuts with a saw -arrow- as illustrated.

Fig 3: Making Two Cuts With A Saw

Courtesy of AUDI OF AMERICA, LLC

-- Remove any burrs on the saw cuts and the hole.