Installing Reverse Gear Clutch

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi A4, 2015 Audi A4, 2014 Audi A4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Insert Corrugated Spring Washer Into Guides Inside Transmission

Courtesy of AUDI OF AMERICA, LLC

NOTE:

As a check, compare the thickness of the new adjustment disc with the thickness of the old adjustment disc performed at the beginning. Refer to REMOVING REVERSE GEAR CLUTCH . The measurement must be repeated if the values between the old and new adjustment discs deviate from each other.

All components must be cleaned thoroughly before inserting.

-- Insert the corrugated spring washer -6- into the guides -1- (3) inside the transmission.

-- Insert the lower adjustment disc "E₁ " -item 2- into the guides inside the transmission.

-- Alternating with the same direction for each lining disc -3- and place an externally toothed plate -5- into the guides inside the transmission.

-- Insert the upper adjustment disc "E₂ " -item 4- into the guides inside the transmission.

-- Adjust the clutch discs of the reverse clutch, for example, with a straight-edge.

Fig 2: Adjust Clutch Discs Of Reverse Clutch

Courtesy of AUDI OF AMERICA, LLC

The grooves must stand exactly in row.

-- Install input shaft, refer to INPUT SHAFT, REMOVING AND INSTALLING .