Overview - Balance Shaft And Oil Pump Drive Chain
WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Crankshaft
- Power Take-Off Drive Chain
- Before removing, mark the direction of rotation with paint
- Removing and installing. Refer to POWER TAKE-OFF DRIVE CHAIN, REMOVING AND INSTALLING .
- Drive Sprocket for Oil Pump
- Installed position: the side with lettering on it faces the engine
- Bolt
- 30 Nm + 90° turn
- Replace
- Pressure Spring
- Bolt
- 15 Nm + 90° additional turn
- Replace
- Balance Shaft Chain Sprocket
- Installed position: the side with lettering on it faces the transmission
- Chain Tensioner
- With glide track
- Bolt
- 10 Nm + 45° additional turn
- Replace