Gear Oil, Draining And Filling, Front Final Drive

WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Used Oil Collection and Extraction Unit SMN372500
Protective eyewear

Filling

The front final drive cover was removed and all of the gear oil has drained through it.
Move the vehicle onto a 4-column shop hoist or over a work pit so it is completely level.
Gear oil temperature at approximately 20 °C (68 °F) (room temperature).
Tightening specification. Refer to OVERVIEW - FINAL DRIVE .

NOTE:

General repair instructions. Refer to GENERAL REPAIR INFORMATION .

Clean working conditions for the automatic transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.

WARNING:

Danger of eye injury.

Wear protective eyewear.

-- Remove the plug -arrow-.

Fig 1: Gear Oil Level In Front Final Drive, Checking And Filling

Courtesy of AUDI OF AMERICA, LLC

-- Fill the front final drive with gear oil slowly over a period of at least 5 minutes until oil drips from the bottom of the inspection opening.

Transmission fluid.

NOTE:

A filling time of at least five minutes is required so that the internal oil level between the differential and oil fill space can equalize.

Replace the drain plug and gasket.

-- Tighten the new sealing plug.

NOTE:

It is not necessary to check the oil level again at this stage.