Input Shaft Seal, Replacing, AUDI A5 Coupe, From My 2008 Through Transmission Series Number 000760

WARNING: This page is about a different car, the 2013 Audi S4, 2012 Audi S4, 2011 Audi S4, and 2010 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Transmission with these transmissions series numbers were installed only in the Audi A5 Coupe from MY 2008.

Special tools and workshop equipment required

Puller - Crankshaft/Power Steering Seal T20143/1
Seal Installer - Crankshaft T10122
Seal Installer - Input Shaft Oil Seal T10184
Sealing Grease G 052 128 A1

Transmission removed. Refer to TRANSMISSION, REMOVING AND INSTALLING .

-- Remove the clutch module. Refer to CLUTCH MODULE, REMOVING AND INSTALLING .

-- Pry out the input shaft seal.

Fig 1: Removing Input Shaft Seal

Courtesy of AUDI OF AMERICA, LLC

-- Lightly coat the outer circumference of the new shaft seal with oil.

Fig 2: Installing Input Shaft Seal

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing and dust lip halfway with Sealing Grease G 052 128 A1.

-- Drive the new seal in until it is flush without tilting it.

-- Install the clutch module. Refer to CLUTCH MODULE, REMOVING AND INSTALLING. .