Install the three-part oil scraping ring
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Pay attention to the spring installation position:
- The plunger of the plates -2 and 3- and the spring -1- must be offset 90° to each other.
- Install by hand.
Installation sequence:
- Insert the spring -1- in the groove.
- Insert the lower plate -3- in the groove.
- Insert the upper plate -2- in the groove.
- Install the upper joint of the 3-part oil scraping ring 120° offset to the neighboring compression ring