Transmission Side Sealing Flange with Six Bolts - Tightening Specifications and Sequence
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Replace the bolts that were tightened with an additional turn after removing them.
- Tighten the bolts in the steps shown in the sequence:
TRANSMISSION SIDE SEALING FLANGE WITH SIX BOLTS - TIGHTENING SPECIFICATIONS AND SEQUENCE
| Step | Bolts | Tightening Specifications |
|---|---|---|
| 1. | -1 to 6- | Install by hand all the way |
| 2. | -1 to 6- | Aluminum bolts: 4 Nm Steel bolts: 9 Nm |
| 3. | -1 to 6- | Aluminum bolts: 45° additional turn |
TIP:
Only six bolts are installed, two bolt openings remain open.