Balance Shaft, Removing And Installing, Intake Side: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Remove the radiator. Refer to RADIATOR, REMOVING AND INSTALLING .
Remove the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .
Remove the balance shaft drive chain. Refer to Balance Shaft Drive Chain, Removing and Installing .

Remove the bolt -2-.
Remove the drive wheel -1- for the coolant pump toothed belt.

Courtesy of

Remove the bolt -1- and the intermediate shaft sprocket.
Remove the mounting pin.

Courtesy of

Remove the bolt -2- on the intake camshaft balance shaft.

Courtesy of
Insert the - T10394/1- from the -T10394- and turn upward in the direction of the -arrow-.

Courtesy of
Insert the -T10394- and push the sliding sleeve in the direction of -arrow-.

Courtesy of
Install the -T10055- into the -T10394- and remove the balance shaft in the direction of -arrow-.

Courtesy of