Balance Shaft, Removing And Installing, Exhaust Side: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- The exhaust side balance shaft must be replaced after removal.
- Because of the small play between the balance shaft and cylinder block, the balance shaft may need to be cooled in order to install it. Check if the balance shaft can be inserted into the cylinder block without forcing it in. If this is not the case, then the balance shaft must be installed cooled.
- Check the installation position for the balance shaft pipe.
The pin -arrow- must engage in the groove.
- Place the new balance shaft in a freezer for 30 minutes or spray it with commercially available cooling spray.
- Lubricate the balance shaft bearing with engine oil.
- Install the new balance shaft for the exhaust side.
- Before tightening the bolt -1- make sure the balance shaft lies level on the crankcase.
NOTE:
If the balance shaft is not level, then the pipe for the balance shaft must be installed again.
Further installation is performed in reverse order of removal, while noting the following:
- Install the balance shaft drive chain. Refer to Balance Shaft Drive Chain, Removing and Installing .
- Install the radiator. Refer to RADIATOR, REMOVING AND INSTALLING .