LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (3.2L - Engine Mechanical, Engine Code(S): BKH) >> 13 - Engine - Crankshaft, Cylinder Block >> Timing chain side, servicing >> Needle bearing on dual mass flywheel (vehicles with manual transmission), pulling out and driving in

Needle bearing on dual mass flywheel (vehicles with manual transmission), pulling out and driving in

WARNING: This page is about a different car, the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Special Tools - Needle Bearing On Dual Mass Flywheel (Vehicles With Manual Transmission), Pulling Out And Driving In
GW00017918Courtesy of VOLKSWAGEN UNITED STATES, INC.

Special tools, testers and auxiliary items required 

Work procedure 

Fig 2: Measuring Depth That Needle Bearing Is Driven Into Dual-Mass Flywheel
GW00017919Courtesy of VOLKSWAGEN UNITED STATES, INC.
Fig 3: Pulling Out Needle Bearing Using Internal Puller Kukko 21/2 And Counter-Support Kukko 22/1
GW00017920Courtesy of VOLKSWAGEN UNITED STATES, INC.
NOTE:
  • The plastic ring in the dual-mass flywheel is affected by impacts. If plastic ring is damaged, the dual-mass flywheel must be replaced.
Fig 4: Driving Needle Bearing Into Flywheel Using 3264 Bearing Driver
GW00017678Courtesy of VOLKSWAGEN UNITED STATES, INC.
Fig 5: Using Backside Of Centering Mandrel 3176 To Press Needle Bearing Further In Until Previously Measured Depth Is Achieved
GW00017921Courtesy of VOLKSWAGEN UNITED STATES, INC.
Fig 6: Measuring Depth That Needle Bearing Is Driven Into Dual-Mass Flywheel
GW00017919Courtesy of VOLKSWAGEN UNITED STATES, INC.
scientia non olet · About LEMON Manuals