Overview - Pedal Assembly, RHD
WARNING: This page is about a different car, the 2013 Audi S4, 2012 Audi S4, 2011 Audi S4, and 2010 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Risk of accident!
- The amount of brake pedal travel must not be decreased by additional floor mats.
NOTE:
Lubricate all bearing areas and contact surfaces with Lubricating Grease G 000 450 02.
Make sure that no brake fluid escapes into the footwell or into the plenum chamber or onto the transmission below. If it does, clean the area thoroughly.
- Clutch Pedal
- Clutch pedal stop
- Mounting pins
- For the clutch master cylinder
- Lubricate the bearing area
- Bearing Bushing
- Clutch pedal mounting axle
- Clip
- Bearings
- Note the different bearing position in the clutch pedal. Refer to "Over-Center Spring Installation Position" in INSTALLING THE OVER-CENTER SPRING .
- Bearing Shell
- Over-Center Spring
- black side faces toward clutch pedal
- Note the different bearing position in the clutch pedal. Refer to Fig 2.
- Removing and installing using the Over-Center Spring Assembly Clamp T40025
- Bearing Shell
- Seal
- Replacing
- Clutch Position Sensor -G476-
- Integrated Clutch Pedal Switch -F36- and Clutch Pedal Starter Interlock Switch -F194-
- Can only be replaced together with the clutch master cylinder, refer to -item 13-
- Clutch Master Cylinder
- Lubricating the bearing lug for the pressure rod
- Bracket
- with the brake pedal
- Seal
- Clip
- Bearing Bushing
- Bolt
- Quantity: 2
- 8 Nm
-- Install the bearing -1- into the clutch pedal.
| Bearing position | Vehicles with: |
|---|---|
|
|
|
|
-- Insert the over-center spring using the Over-Center Spring Assembly Clamp T40025.
- The white side of the over-center spring faces the bearing -1-.