Clutch Slave Cylinder, Installing

WARNING: This page is about a different car, the 2013 Audi S4, 2012 Audi S4, 2011 Audi S4, and 2010 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

If damaged, replace the O-ring.

If clutch slave cylinder is guided on at an angle, there is the danger that the plunger may be guided past the clutch release lever.

-- Preload the clutch slave cylinder -1- enough that the mounting bolt -3- can be inserted easily. Tightening specification, refer to "Clutch Hydraulics" -item 17- Bolt (See Figure).

Fig 1: Identifying Clutch Slave Cylinder

Courtesy of AUDI OF AMERICA, LLC

-- Press the clip -2- all the way in.

-- Insert the line into the clutch slave cylinder until it engages.

-- Pull on the hose/line assembly to make sure it is secure.

-- Bleed the clutch system. Refer to CLUTCH MECHANISM, BLEEDING .

-- Install the rear noise insulation. Refer to OVERVIEW - NOISE INSULATION .