Clutch Pedal, Removing And Installing: Installing
WARNING: This page is about a different car, the 2013 Audi S4, 2012 Audi S4, 2011 Audi S4, and 2010 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Lubricate all bearing areas and contact surfaces with Lubricating Grease G 000 450 02.
-- Install the clutch pedal -3- and install the bearing axle -1- and lock it in direction of -arrow A-. The securing tab -2- must engage on the bottom of the pedal bracket.
-- Install the mounting pins -4-. The shoulder on the pin -arrow B- must be guided into the groove in the clutch pedal.
-- Install the over-center spring. Refer to INSTALLING THE OVER-CENTER SPRING .
-- Install the mounting bracket. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING .