Overview - Pedal Assembly, RHD
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, 2014 Audi S4, and 2014 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Risk of accident!
- The amount of brake pedal travel must not be decreased by additional floor mats.
NOTE:
Lubricate all bearing areas and contact surfaces with Lubricating Grease G 000 450 02.
Make sure that no brake fluid escapes into the footwell or into the plenum chamber or onto the transmission below. If it does, clean the area thoroughly.
- Clutch Pedal
- Clutch pedal stop
- Mounting pins
- For the clutch master cylinder
- Lubricate the bearing area
- Bearing Bushing
- Clutch pedal mounting axle
- Lubricate the bearing area
- Clip
- Bearings
- Note the different bearing position in the clutch pedal. Refer to OVER-CENTER SPRING, REMOVING AND INSTALLING .
- Bearing Shell
- Over-Center Spring
- black side faces toward clutch pedal
- Note the different bearing position in the clutch pedal. Refer to Fig 2.
- Allocate according to engine code.
- Bearing Shell
- Seal
- Replacing
- Clutch Position Sensor -G476-
- Integrated Clutch Pedal Switch -F36- and Clutch Pedal Starter Interlock Switch -F194-
- Can only be replaced together with the clutch master cylinder, -item 13-
- Clutch Master Cylinder
- Lubricating the bearing lug for the pressure rod
- Bracket
- with the brake pedal
- Seal
- Clip
- Bearing Bushing
- Bolt
- Quantity: 2
- 8 Nm
-- Install the bearing -1- into the clutch pedal.
| Bearing position | Over-Center Spring Color |
|---|---|
|
|
|
|