Clutch Slave Cylinder, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, 2014 Audi S4, and 2014 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
NOTE:
If damaged, replace the O-ring.
If clutch slave cylinder is guided on at an angle, there is the danger that the plunger may be guided past the clutch release lever.
-- Preload the clutch slave cylinder -1- enough that the mounting bolt -3- can be inserted easily. Tightening specification, refer to -item 17- Bolt.
-- Press the clip -2- all the way in.
-- Push the hose/line assembly into clutch slave cylinder until assembly audibly engages.
-- Pull on the hose/line assembly to make sure it is secure.
-- Bleed the clutch system. Refer to CLUTCH MECHANISM, BLEEDING .
-- If equipped install the rear the noise insulation. Refer to NOISE INSULATION .