Clutch Pedal, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, 2014 Audi S4, and 2014 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
CAUTION:
"Rattling noises" when using the clutch.
- "Rattling noises" can occur when pressing the clutch if there is not enough grease in the bearing area on the clutch pedal or especially on the lug for the master cylinder pressure rod.
- Lubricate all bearing areas and contact surfaces with Lubricating Grease G 000 450 02.
-- Install the clutch pedal -3- and install the bearing axle -1- and lock it in direction of -arrow A-. The securing tab -2- must engage on the bottom of the pedal bracket.
-- Install the mounting pins -4-. The shoulder on the pin -arrow B- must be guided into the groove in the clutch pedal.
-- Over-center spring, installing. Refer to INSTALLING THE OVER-CENTER SPRING .
-- Install the bracket. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING, VEHICLES WITH MANUAL TRANSMISSION .