Right Flange Shaft Seal
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Audi A4 Quattro, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Oil Collecting and Extracting Device VAG 1782
- Extractor Lever VW 681
- Thrust Piece T40189
Procedure
NOTE:
Clean working conditions for the automatic transmission. Refer to CLEAN WORKING CONDITIONS .
General repair instructions, refer to REPAIR INFORMATION .
-- Place the VAG 1782 under the transmission.
-- Remove the right flange shaft. Refer to RIGHT FLANGE SHAFT .
-- Remove the right flange shaft seal.
-- Coat the outer circumference of the new shaft seal with axle oil.
- Installed position: The open side of the shaft seal faces the transmission.
-- Drive on in new shaft seal as far as stop. When doing this, do not bend the shaft seal or install it on an angle.
-- Install the right flange shaft. Refer to RIGHT FLANGE SHAFT .
-- Axle oil, adding to transmission after repair. Refer to GEAR OIL IN FRONT FINAL DRIVE, FILLING AFTER REPAIR .