9-way relay carrier, removing and installing

WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove driver's storage compartment:

Refer to 68 - INTERIOR EQUIPMENT

Fig 1: Identifying 9-Way Relay Carrier, Assembly Overview

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove nuts -3- and remove Vehicle Electrical System Control Module -J519- with cables connected.
Remove 9-way relay carrier -4-.
Unclip fuse carrier at 9-way relay carrier.
Remove relays, control modules, and then unclip respective relay carrier.

NOTE:

Fig 2: Identifying 9-Way Relay Carrier

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Precise location of 9-way relay carrier should be taken from appropriate wiring diagram.

Refer to Electrical Wiring Diagrams, Troubleshooting & Component Locations

Installing

Installation is the reverse of removal.

Tightening torque

Component		Nm
9-way relay carrier with vehicle electrical system control module to center tube for instrument panel		2.4