Tail light to vehicle contour, aligning
WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Tail light removed. Refer to Tail light and bulb carrier, removing and installing .
- Change position of adjusting elements in steps with tail light removed.
- Install again each time as an adjustment check of the taillight.
1 - Interior adjustment in longitudinal direction
2 - Adjustment perpendicular to direction of travel
(for this, loosen nut -3-)
4 - Upper adjustment in longitudinal direction
5 - Lower adjustment in longitudinal direction
- Reinstall. Refer to Installing .
Tightening torque
| Component | Nm | |
| Nut for tail light to retainer piece | 12 | |