Positive terminal in plenum chamber - Audi RS4, removing and installing

Removing 

• Disconnect battery → Battery in luggage compartment, disconnecting and connecting .

Fig 1: Identifying Plenum Chamber Cover & Removing Rubber Seal

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove plenum chamber cover rubber seal in direction of - arrow  -.
• Remove plenum chamber cover - 1  - forward.

Fig 2: Removing Screw, Retaining Clip, And Positive Terminal

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove screw - 1  -.
• Release retaining clip - 2  - in direction of - arrow A  -.
• Remove positive terminal in direction of - arrow B  - from bracket.

Fig 3: Releasing Retaining Clip And Opening Cover Over Positive Terminal Pick-Off

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Release retaining clip - arrow A  - and open cover - 2  - over positive terminal.
• Release wiring cover - 1  - in direction of - arrow B  -.

Fig 4: Removing Terminal Nuts, Cables, And Positive Terminal

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove terminal nuts - 1  - and - 4  - and remove cables.
• Remove positive terminal.

Installing 

Install in reverse order of removal, noting the following:

• Connect battery. Required steps Connecting .

Tightening torques