9-position relay carrier, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Where applicable, remove drivers storage compartment → 68 - INTERIOR EQUIPMENT .

Fig 1: Identifying Nuts, And Relay Carrier

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove nuts - 3 - remove Vehicle Electrical System Control Module J519 with wires attached.
Remove 9-position relay carrier - 4 -.

NOTE:

Disregard - 1 - and - 2 -.
Unclip the fuse carriers at the 9-position relay carrier.
Remove relays and control modules and then unclip appropriate relay carrier.

Fig 2: Identifying 9-Way Relay Carrier

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE:

Refer to the applicable wiring diagram for exact identification of connections on relay carrier Wiring Diagrams.

Installing

Install in reverse order of removal, noting the following:

Install drivers storage compartment → 68 - INTERIOR EQUIPMENT .

Tightening torque

Component - fastener	Nm
9-position relay carrier to central tube for instrument panel - nut	2.4