Rear door power window switches, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove rear door trim: → 70 - INTERIOR TRIM .

Fig 1: Locating Screws

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screws - 1... 3 -.
Remove armrest and disconnect electrical connection.

Fig 2: Pulling Switch Mounting From Armrest

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pull switch mounting - 1 - from armrest - 2 - - arrow -.

Fig 3: Using Small Screwdriver To Carefully Release Fasteners

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Use small screwdriver to carefully release fasteners - arrows -.
Pull out window switch downwards.

Installing

Install in reverse order of removal, noting the following:

Press window switch into switch mounting until retaining hooks engage.
Install rear door trim → 70 - INTERIOR TRIM .