Drivers power window switch panel - four switches, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove front door trim → 70 - INTERIOR TRIM .

Fig 1: Identifying Retaining Element, Retaining Hooks, Window Switches, And Electrical Connection

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release retaining hooks on armrest side by pressing retaining element - arrows -.
Use small screwdriver to carefully release retaining hooks - 1 - on trim side.
Pull window switches - 2 - downwards out of door trim.
Disconnect electrical connection - 3 - at window switch.

Installing

Install in reverse order of removal, noting the following:

Press window switch into switch mounting until it engages.
Install front door trim → 70 - INTERIOR TRIM .