Signal Horn/Dual Tone Horn H1 - from 11.04, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Vehicles without charge air cooler or additional radiator:

Fig 1: Identifying Quick-Release Fasteners And Noise Insulation

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release fasteners - 1 - and - 2 - and remove front noise insulation.

Vehicles with charge air cooler or additional radiator:

Remove front bumper cover → 63 BUMPER .

Fig 2: Disconnecting Left/Right Electrical Connectors Of Horns

Courtesy of VOLKSWAGEN UNITED STATES, INC.

All models:

Disconnect electrical connection - 3 -.
Remove nut - 1 - and detach horn - 2 - from retainer.

NOTE:

Illustration shows bumper removed for clarity.

Installing

Install in reverse order of removal, noting the following:

Vehicles with charge air cooler or additional radiator:

Install front bumper cover → 63 BUMPER .

Tightening torque

Component - fastener	Nm
Horn to bracket - nut	5