Alarm Horn H12 , removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Remove right interior trim → 70 - INTERIOR TRIM .

Fig 1: Identifying Nut, Electrical Connection, Horn, Bolt, And Horn Bracket

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove nut - 1 -.
Disconnect electrical connection - 2 -.
Remove horn - 3 -.
If necessary, remove horn bracket - 5 - by removing bolt - 4 -.

Installing

Install in reverse order of removal, noting the following:

Install trim → 70 - INTERIOR TRIM .

Tightening torque

Component - fastener	Nm
Alarm Horn H12 to bracket - nut	5
Bracket to body - bolt	9