Side mounted turn signals, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Turn light switch to position "0".

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Fig 1: Pushing Turn Signal Light/Housing Against Retainer

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press turn signal housing towards front of vehicle against retainer tab - arrow - and remove carefully from fender opening.
Disconnect electrical connection.

Installing

Install in reverse order of removal.